Karma EQ bullpup PCP air rifle resting on a rear bag on a stump during the Puerto Rico iguana hunt

Karma EQ on a Bipod or Tripod: Saber Tactical Bottle Adapter Kit, Carbon Fiber Bottles and Bottle Clamps for Balance

The first time I carried a Karma EQ for real was three straight days in the Puerto Rico jungle with Abner Almenas of Puerto Rico Xtreme Outdoors, and by the end of that trip I had a pretty clear picture of what this bullpup does well and where the setup could get better. The .25 caliber EQ I was running pushed 34 grain pellets at 920 FPS, it got banged off trees and nearly went into a drainage ditch with me while I was recovering an iguana, and it still held zero and kept dropping head shots from 50 to 70 yards. What it did not have was a rigid place to hang a bipod or lock into a tripod, and the factory tank carries a lot of the rifle's weight, so this Field Notes is about how the Saber Tactical Karma EQ Bottle Adapter Kit and our bottle clamps let you rebuild the EQ around the way you actually shoot it, whether that is off a bench, off sticks, or off a bipod in the prone.

Hero photo: the Karma EQ on a rear bag over a stump during the Puerto Rico iguana hunt. Photos in this post are stills from my own YouTube videos, @upnorthairgunner on Instagram.

Quick Summary

  • The problem: the Karma EQ is overbuilt and holds zero through real abuse, but the factory tank is heavy, it sets where the weight lives, and the stock rifle has no dedicated bipod or tripod interface under the air.
  • The air side fix: the Saber Tactical Karma EQ Bottle Adapter Kit lets you swap the factory tank for a carbon fiber bottle, from a compact 300cc up to 480cc, 580cc or 700cc, so you choose how much weight and how much air the rifle carries.
  • The support side fix: a Saber Tactical bottle clamp, or one of the full-circumference Bottle O-Clamps, gives you a Picatinny or Arca point on the bottle for a bipod, a tripod head or a side accessory.
  • Real numbers from my testing: the .22 caliber EQ with its 600mm barrel ran sub-MOA at 50 yards with Zan ELR at 865 FPS, Zan 28 grain at 950 FPS, FX Hybrids at 1000 FPS and AEA 38.6 grain at 900 FPS, and PJ and I pushed it to 75 FPE with the AEA 38 grain slugs.

How the Karma EQ Carries Its Weight in the Field

The EQ is a heavy rifle, and I am not going to pretend otherwise, but the way that weight sits is a big part of why it shot so well off my Primos Trigger Sticks in Puerto Rico. A lot of the mass is toward the center and rear of the rifle, so offhand and off sticks you are not fighting a muzzle-heavy gun that drags your arms down after a few hours of glassing trees. When I tore one down with Abner after the hunt, it was obvious why it held zero through all that abuse, because the barrel is basically a miniature version of the Karma Red Panda bull barrel with eight heavy duty bolts tying it to the action, and that is one of the most overbuilt barrel to action designs I have ever had apart on a bench.

The flip side is that the factory tank is a big chunk of that weight hanging under the barrel, and Karma dealers list it at 500cc and 310 bar. That is plenty of air for a long day of pesting with the high capacity magazine, but it also means the tank decides your weight and your balance point for you, and on a bipod or a tripod the tank is really the only place on the front half of the rifle to build a solid contact point.

Karma EQ with a Saber Tactical bottle clamp on the factory tank giving the bipod a mounting point at the bench

My .22 caliber Karma EQ at DonnyFL headquarters with a Saber Tactical bottle clamp on the factory tank, which is what gave the bipod somewhere rigid to live during slug testing.

Why Put a Bottle Clamp on the Karma EQ?

Back in my first review I said that if you want to run a bipod or tripod system full time on the EQ, adding a Saber Tactical bottle clamp with an Arca or Picatinny interface is the move, and when I got the .22 caliber version to DonnyFL headquarters for slug testing that is exactly what I did. The clamp wraps the tank, puts a rail on the bottom, and turns the front of the rifle into a real support point, so the bipod loads into the clamp instead of you trying to balance a bullpup on a bag that is sitting under a round tank.

Where you set that clamp along the tank matters more than people think. Run it as far forward as the tank allows when you are on a bipod, because a longer distance between the bipod and the rear bag gives you a more stable platform and lets you load the bipod with a little forward pressure so the rifle comes straight back and settles in the same spot after the shot. When the rifle goes onto a tripod, slide the clamp back toward the balance point so the head carries the weight of the rifle and you are only steering the reticle, instead of holding up a rear-heavy bullpup with your shooting hand.

If you are loading hard into a bipod at the bench, or you want a side rail for a chronograph or a light, PJ and I recommend the full-circumference Bottle O-Clamp, which wraps the entire bottle, uses rubberized inserts tensioned by set screws so it will not mar the finish, and gives you Picatinny on the side with your choice of Picatinny or Arca on the bottom. Bottle diameters vary even inside the same model, so put a set of calipers on your tank or bottle before you order and match the clamp size to that number.

UpNorth AirGunner Chris Turek at the bench with the Karma EQ on a bipod during slug testing at DonnyFL headquarters

Slug testing the Karma EQ off a bipod and rear bag at DonnyFL headquarters.

What the Karma EQ Shot Once It Was Supported

With the EQ sitting on a bipod and a rear bag, I ran over a dozen different .22 caliber slugs from 22 to 42.3 grains through the 600mm, 1 in 17.7 twist barrel, from about 850 FPS up to 1050 FPS with the lighter slugs, working each one across its power band at my 50 yard tuning range. The winners that day were the Zan ELR at 865 FPS, the Zan 28 grain at 950 FPS, the FX Hybrids at 1000 FPS and the AEA 38.6 grain hollow points at 900 FPS, and all four of them grouped sub-MOA at 50 yards. I also had the FX Hybrids wound up to 1050 FPS regulated at 2000 PSI holding dime sized groups at 50 yards, and earlier PJ and I pushed this same 600mm rig to 75 FPE with the AEA 38 grain slugs.

The trigger update Karma made after our early feedback mattered here too, because a precision test is only as good as your ability to break the shot without moving the rifle, and the revised adjustable trigger with less first stage travel turned the EQ from a decent field trigger into a very good one for shooting groups. A supported rifle and a clean trigger are what let you separate what the barrel and the slug are doing from what you are doing, which is the whole point of chasing precision at the bench.

What the Saber Tactical Karma EQ Bottle Adapter Kit Changes

The Saber Tactical Karma EQ Bottle Adapter Kit replaces the factory tank interface so you can run a carbon fiber bottle on the EQ, and that is really a weight and balance decision as much as an air decision. A compact 300cc bottle strips weight off the front half of the rifle for a lighter carry gun when you are walking and shooting off sticks, while a 480cc, 580cc or 700cc bottle gives you longer shot strings for a day of pesting or a long bench session. Because the bottle hangs forward under the barrel, the size you pick changes how much mass sits out front, so think about where you shoot most before you pick one, and then set your clamp position for that bottle rather than carrying over a position from the factory tank.

Saber Tactical Karma EQ Bottle Adapter Kit installed with a compact carbon fiber bottle on the Karma EQ

The Saber Tactical Karma EQ Bottle Adapter Kit with a compact carbon fiber bottle installed on the EQ.

What Comes in the Kit

The kit includes the main adapter body with its four-port design, a thread protector collar, O-rings and X-washers with spares, and a Foster fitting plunger assembly. The four ports are what let you choose the orientation of your Foster fill fitting, so you can put the fill port where it is easy to reach with your fill whip on the way your rifle actually sits on the bench or in the truck.

Saber Tactical Karma EQ Bottle Adapter Kit contents with adapter body, thread protector collar, Foster fill fitting, O-rings and X-washers

Installing It at Home

This is a basic tools job, which means open-end wrenches, an Allen key and some Teflon tape, but it starts with a completely degassed rifle, every time, with no exceptions. Take your time seating the O-rings, put the Foster fitting in the port that makes sense for how you fill, and check for leaks at a low fill before you take it all the way up.

The one rule you cannot ignore is fill pressure. If your carbon fiber bottle is rated for 250 bar, your rifle is now a 250 bar rifle, which is about 3600 PSI, no matter what the factory tank was rated for, so always match your fill pressure to the bottle's rating and keep that in mind when you set your regulator and plan your shot count.

Top view of the Saber Tactical Karma EQ Bottle Adapter Kit with gauge, Foster fill port and carbon fiber bottle

How I Would Set Up a Karma EQ Today

For a hunting rifle that lives on shooting sticks, I would pair the adapter kit with a compact carbon bottle and a lighter optic like the Element Helix Compact or the Element Immersive, because in Puerto Rico I was carrying a full camera rig on the scope and I felt every ounce of it by the end of the day. For a bench or pesting rifle that spends its life on a bipod, I would run a larger bottle for the shot count and put a Bottle O-Clamp out front, with the Arca version if your bipod or tripod lives on Arca and the Picatinny version if it does not. Either way, set the rifle on a bag at the clamp and see where it wants to sit level on its own, because if you have to hold the forend down or the butt up to keep it there, the clamp position or the bottle size is wrong for that position.

If you want the full rundown of clamp sizes, our bottle clamp fit guide walks through every one side by side, and my Bottle O-Clamp chronograph and bipod setup shows how I use the side rail on the FX King and why it makes sense on heavy bullpups.

Saber Tactical Karma EQ Bottle Adapter Kit product photo
Karma EQ Bottle Adapter Kit
Run carbon fiber bottles from 300cc to 700cc on the Karma EQ.
Shop the Adapter Kit
Saber Tactical Picatinny Bottle O-Clamp product photo
Picatinny Bottle O-Clamp
Full-circumference bipod and tripod point in 52, 60 and 63mm.
Shop the Picatinny O-Clamp
Saber Tactical Arca Bottle O-Clamp product photo
Arca Bottle O-Clamp
Arca on the bottom and Picatinny on the side, in 52 and 60mm.
Shop the Arca O-Clamp

FAQ: Karma EQ Bottle Adapter Kit, Carbon Bottles and Bipod Mounting

What does the Saber Tactical Karma EQ Bottle Adapter Kit do?

It lets you run a carbon fiber bottle on the Karma EQ in place of the factory tank, with a four-port adapter body so you can pick your Foster fill fitting orientation, plus a thread protector collar, O-rings, X-washers and a Foster plunger assembly.

What bottle sizes work with the Karma EQ adapter kit?

The kit is designed for carbon fiber bottles including 480cc, 580cc and 700cc sizes, and a compact 300cc bottle if you want the lightest carry setup.

Does a 250 bar bottle change my fill pressure?

Yes, with a 250 bar bottle installed your rifle is limited to 250 bar, about 3600 PSI, so always match your fill pressure to the bottle's rating.

How do I mount a bipod on a Karma EQ?

Put a Saber Tactical bottle clamp or Bottle O-Clamp on the tank or bottle to give the bipod a Picatinny or Arca interface, set it as far forward as possible for bipod work, and slide it back toward the balance point when the rifle goes on a tripod.

Which bottle clamp size fits my Karma EQ?

Measure the outside diameter of your factory tank or carbon bottle with calipers before ordering, because bottle diameters vary even within the same model, and then match the clamp size to that measurement.

What SKU is the Karma EQ Bottle Adapter Kit?

It is listed as ST0100 on the Saber Tactical store, and the Bottle O-Clamps are ST0096, ST0097 and ST0104 in Picatinny and ST0101 and ST0102 in Arca.

If you have questions about setting up a Karma EQ for the bench or the field, reach out to us at Saber Tactical and PJ and I will help you get it sorted, and if you want to watch the EQ in action, the full Karma EQ and SLS Puerto Rico review and the Karma EQ slug testing and trigger video are up on my YouTube channel, UpNorth AirGunner, with more on Instagram at @upnorthairgunner.